a. Place probe on part in the inspection locations and null. Adjust phase as required to obtain horizontal lift-off.
b. Inspect the part.
c. Any signal similar to the notches in the test block is cause for rejection.
Either probe identified in paragraph 184.108.40.206 may be used depending primarily on the ease of
accessibility and user friendliness. If the probes are changed, steps 220.127.116.11 b. (1), (2), and (3)
shall be repeated each time a change is made.
18.104.22.168 Marking and Recording of Inspection Results. Mark and record as required by paragraph 1.3.
5.3.5 System Securing. The engine mount cap, if removed, requires installation in accordance with applicable
technical manuals listed in Table 1-1. Secure the engine upper and lower doors.