TB 1-1615-351-23
UH-60 Rotor Blade Erosion/Spark Guard Kit
NSN 1615-01-209-6097, Task Research P/N 25-1012-00
Kit
Quantity
Instruction sheets
2 each
Masking tape, 1" x 60 yd (Grade B)
3 rolls
Sandpaper, 80 grit, 2 1/2 x 18" strip
10 sheet
Wiping cloth, paper cheesecloth
12 each
Gloves, disposable, large size
24 pair
Brushes, disposable, 2" wide bristles
30 each
Trash bag, small
3 each
Paper towel, folded
2 pkg
Task L-100 prepackage kit #25-1004-00
64 kit
UH-60 Main Rotor Application Dimensions and Quantities
First coat
1 can to 4 blades
1" wide by 48" long
(1/4 can per blade)
Second coat
1 can to 2 blades
1 1/4" wide by 72" long
(1/2 can per blade)
Third coat
1 can to 1 blade
1 1/2" wide by 108" long
Fourth coat
2 cans to 1 blade
2" wide by 144" long
Fifth coat
4 cans to 1 blade
Entire top of blade to 1" overlap on
bottom plus swept tip area on the
bottom as called out on illustration.
Sixth coat
5 cans to 1 blade
Entire bottom of blade to 1" overlap
on top.
NOTE: If the fifth coat has produced slight runs or sags, the touch up procedure of para 1-6 i should be
performed before the sixth coat is applied. If the blades were removed before painting, then the blade should be
turned upside down before applying the sixth coat to the bottom. The sixth coat should not be applied until the
fifth coat has set to be at least tacky to the touch.
UH-60 Tail Rotor Application Dimensions and Quantities
First coat
1/2 can to 2 blades
1" wide by 18" long
Second coat
1/2 can to 2 blades
1 1/2" wide by 20" long
Third coat
1/2 can to 2 blades
2" wide by 22" long
Fourth coat
1 can to 1 blade
Total application area
