NAVAIR 01-1A-505-2
010 03
TO 00-25-255-1
Page 6
TM 1-1500-323-24-2
Figure 5. Tightening Position of Wrench
NOTE
(WP 007 03, this manual) for detailed information on
the following cable clamps: M85049/1, M85049/2,
As all NAVAIR connector and accessory
M85049/41 and M85049/42.
documents are transitioned to non-government
standards, (the Society of Automotive
14. Strain Reliefs. A strain relief is a support or clamping
Engineers (SAE), will become the preparing
device which attaches directly to connector. See
activity and the Navy will adopt the
(WP 007 03, this manual) for detailed information on
documents), the drawing number prefix will
the following strain reliefs: M85049/43, M85049/51,
change from MS to AS. The main part number
M85049/52, M85049/53, M85049/54, and M85049/55.
designation remains the same, with the "M"
prefix, such as M81511/17-08. At times the
15. SHRINK BOOTS AND ADAPTERS. Boots and
entire item may be superseded by another.
adapters are protective coverings over any portion of a
There are many cases where documents have
cable, wire, or connector in addition to normal jacketing
been cancelled without replacements, each case
or insulation. A protective housing usually made from
was reviewed and some information has been
a resilient material to prevent entry of moisture into a
retained in this volume "for reference use only".
connector. See WP 008 03 for information on shrink
boots: MS3109 (or AS31091) and MS3117 (or AS31171)
11. GROMMET NUTS. The grommet nut is a threaded
and adapters: M85049/60-1 and M85049/60-2.
ring nut utilized to securely bold connector grommet
in place. See WP 007 03, this manual for detailed
16. EMI/RFI GROUNDING TERMINATORS. Ground
information on the M85049/31 grommet nut.
terminators are used to ground or shield a connector to
12. CABLE CLAMPS/STRAIN RELIEFS. The following
interference from other equipment. A physical and
two paragraphs explain the two types of cable support
electrical shield is employed which is terminated at
or clamping devices.
one or both ends to a ground or some other
predetermined point with respect to ground. Shields
13. Cable Clamps. A cable clamp is a support or
can be applied to individual wires, cables, bundles, or
clamping device which requires use of an intermediate
harnesses. See WP 007 03 for information on grounding
component for attachment to back of connector. See
terminators: MS18121, MS21980, and MS21981. Refer
