TM 1-1510-254-CL
* FIRST ENGINE START (GPU START)
1. Exterior LIGHTS switches -- As required.
2. Propeller area -- Clear.
3. Engine -- Start.
4. CONDITION lever -- HIGH IDLE. Monitor
ITT as CONDITION lever is advanced.
5. GPU -- Disconnect as required.
6. GEN (after GPU disconnected) -- RESET,
then ON.
* SECOND ENGINE START (GPU START)
1. Propeller area -- Clear.
2. Engine -- Start.
3. Engine instruments -- Check.
4. #2 PROP lever -- FEATHER.
5. GPU -- Disconnect.
6. #2 PROP lever -- HIGH RPM.
7. CONDITION lever -- HIGH IDLE.
8. GEN # 1 -- RESET, then ON.
9. Current limiter -- Check.
10. GEN # 2 -- RESET, then ON.
BEFORE TAXIING
* 1. CMWS PWR -- ON.
* 2. CABIN TEMP MODE and TEMP controls --
Set as desired. (Aft blower as necessary).
* 3. AVIONICS MASTER PWR switch -- ON.
4. ELECTRIC TRIM -- Check.
5. AUTOPILOT SYSTEM -- Check.
6. LX/RDR STORMSCOPE -- STBY.
* 7. FMS -- Initialize and set.
* 8. V-Speeds -- Set.
* 9. BRAKE DEICE -- Check irst light of the day
and set as required.
* 10. CMWS -- BIT checks as required.
* 11. TCAS / EGPWS -- Check and set.
Change 1 N-5