TM 1-1520-264-23
Figure 6-41. Tail Rotor Drive Links
NOTE
Either probe identified in paragraph 6.41.3.1 may be used depending primarily on the ease of accessibility and user
friendliness. If the probes are changed, steps 6.41.3.5 b. (1), (2), and (3) shall be repeated each time a change is
made.
6.41.3.7
Marking and Recording of Inspection Results. Mark and record the inspection results as required by
paragraph 1.3.
6.41.4
Backup Method. None required.
6.41.5
System Securing. The tail rotor drive links, if removed, require installation in accordance with the applicable
technical manuals listed in Table 1-1.
6.42
EXTERIOR
SURFACES
OF
ALL
FERROUS
HYDRAULIC
COMPONENTS
(SERVOCYLINDERS,
ACTUATORS, RESERVOIRS, ETC.) (MT).
6.42.1
Description (Figure 6-1. Index No. 42). Inspect the exterior surfaces of all ferrous hydraulic components
(servocylinders, actuators, reservoirs, etc.) found in the areas of the aft/forward main rotor mast and the aft/above top
rotor mast.
6.42.2
Defects. This inspection is used to verify crack indications found visually on the exterior surfaces of all
ferrous hydraulic components. No cracks are allowed.
6-88
