TM 1-6625-476-30
4-13
4-11. DAY SENSOR SUBASSEMBLY REMOVAL FROM DAYSIDE TEST BENCH.
This paragraph covers the steps required to remove the day sensor subassembly from the dayside test
bench and install it in the shipping and storage container.
a. Preparation of Shipping and Storage Container.
WARNING
HEAVY OBJECTS
Excessive strain can cause serious injury.
Don't: Attempt to lift or carry heavy objects alone.
Do: Get help for lifting or carrying heavy loads.
If you experience a sudden pain while lifting or discomfort after lifting, get
medical help at once.
NOTE
Two people are required when performing this task.
(1) Remove inner case assembly from shipping and storage container as follows.
(a) Press pressure relief (1, figure 4-7) on container.
(b) Release and unhook container latches (2).
(c) Remove container cover (3) and set aside on clean dry surface.
(d) Remove case assembly (4) from container and place on workbench.
(2) Release and disengage latches (5) securing case assembly (6) to base assembly (7).
(3) Grasp handles (8) and lift case assembly clear of base assembly. Place case assembly on
clean dry surface.
