TM 1-6625-476-30
5-2
5-3. PRECAUTIONS. (CONT)
Figure 5-1. Control Panel Assembly
Section II. DESCRIPTION OF TEST
Subject
Para
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-4
5-2
Test Concept . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-5
5-2
Test Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-6
5-3
Pretesting Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-7
5-3
Final Acceptance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-8
5-3
5-4. GENERAL.
This section describes the UUT test for the control panel assembly. It includes an explanation of the way
testing is accomplished, a description of the test, and pretesting data.
5-5. TEST CONCEPT.
The UUT test for the control panel assembly is supplemented by procedures in section III of this chapter,
and by illustrations in section IV. While you are performing the UUT test, message prompts on the VDT
will direct you to perform one of the procedures in section III, or to refer to an illustration in section IV.
a. Procedures. Section III contains procedures to remove the control panel assembly from the and
storage container and to replace it in the container. These procedures do not apply to the UUT test until
called for by the test program. At the appropriate time during the test, a message prompt on the VDT will
direct you to perform a set of procedures in this section. At that time, turn to the referenced paragraph
and perform those procedures, as the program cannot continue until they have been performed.
