TM 10-4930-351-14
0007 00
PREPARATION FOR MOVEMENT (Continued)
13. Disconnect inlet manifold from fuel transfer pump quick disconnect. Drain inlet manifold and stow in storage module.
14. If attached, remove manual starter from pump-engine module and stow in container.
a.
Lower engine module clamp, and disengage and remove manual starter.
b.
Install and latch the coupling guard at front of engine module.
15. Remove air cleaner from engine and stow in storage module. Install dust cap on intake manifold.
WARNING
Serious injury could occur if heavy equipment is moved/lifted without sufficient personnel to do the
job. Always use sufficient personnel to move or relocate the accessory module. Use proper physical
lifting procedures or use a suitable lifting device or dolly. Wear safety shoes, gloves, and other
suitable protective clothing.
16. Return accessory module to recovery area.
WARNING
Serious injury could occur if heavy equipment is moved/lifted without sufficient personnel to do the
job. Always use sufficient personnel to move or relocate the engine module. Use proper physical
lifting procedures or use a suitable lifting device or dolly. Wear safety shoes, gloves, and other
suitable protective clothing.
17. Remove engine module from pump-engine module.
a.
Unclamp exhaust pipe from exhaust manifold.
b.
Disconnect pumpage overtemperature cable at engine module connection panel. Install dust caps on connectors.
Wrap free end of cable around fuel transfer pump outlet.
c.
Disconnect fuel supply and return lines at engine module. Connect free ends of lines together.
d.
Unlatch engine module from pump-engine frame and slide engine module out of frame.
18. Return engine module to recovery area.
19. Return pump-engine module to recovery area.
20. Install engine module in pump-engine module.
a.
Slide engine module into pump-engine module, PTO end first. If flex coupling will not engage, it may be necessary
to rotate the flex portion slightly to align with the engine adapter.
b.
Latch engine module to pump-engine frame.
c.
Clamp exhaust pipe to exhaust manifold.
d.
Connect pumpage overtemperature cable at engine module connection panel connector J3. Connect adjacent dust
caps together.
0007 00-33