TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPAIR BATTERY HOLDDOWN
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Took Kit, General Mechanics
NOTE
This procedure applies to either battery holddown.
REMOVAL
1.
At accessory module, unlatch and raise battery compartment cover (1).
2.
At holddown eyebolt (2), remove wingnut (3), two flat washers (4), lock washer (5) and self-locking nut (6). Discard
lock washer (5) and self-locking nut (6).
3.
At bottom of eyebolt (2), remove shoulder bolt (7), flat washer (8), lock washer (9) and hex nut (10). Discard lock
washer (9). Remove eyebolt from battery compartment.
INSTALLATION
1.
Insert eyebolt (2) through bottom of battery compartment, align eye with mounting hole in frame, and install shoulder
bolt (7), flat washer (8), lock washer (9) and hex nut (10).
2.
At upper end of holddown eyebolt (2), install self-locking nut (6), two flat washers (4), lock washer (5) and wingnut (3).
3.
Adjust wingnut for snug fit of holddown assembly under battery ear.
4.
Lower and latch battery compartment cover (1).
0053 00-1