TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPLACE CONTROL PANEL LAMP ASSEMBLIES/PANEL LIGHTS
This procedure applies to the four panel lamps (CR1, CR2, CR3 and CR5), and the four malfunction indicators (CR6, CR7,
CR8 and CR9). Refer to WP 0061 00 for component location.
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Screwdriver, Cross Tip, #2
Combination Wrench, 1/2"
Pliers, Long Nose, 8"
REMOVE LAMP ASSEMBLY/PANEL LIGHT
1.
Remove the twenty-four screws (1) and flat washers (2) that secure the control panel (3) to the control box.
2.
Lift the control panel (3) from the control box and set on edge convenient to lamp assembly to be replaced.
3.
Remove tie wraps from lamp assembly wires as required.
4.
Tag leads near base of lamp assembly (4) for installation.
5.
Remove indicator light lens (5)/miniature indicator cap (6) and lamp (7 or 8).
6.
Desolder leads from indicator light housing (4) terminals.
7.
Remove nut (9) and lock washer (10) that secure indicator light housing to control panel (3).
INSTALL LAMP ASSEMBLY/PANEL LIGHT
1.
Install indicator light housing (4) on control panel (3) with nut (9) and lock washer (10).
2.
Solder leads to indicator light housing (4) terminals as tagged. Remove tags.
3.
Install tie wraps on wiring harness as required.
4.
Install lamp (7 or 8) and indicator light lens (5)/miniature indicator cap (6).
5.
Install control panel (3) in control box with twenty-four screws (1) and flat washers (2).
0062 00-1