TM 10-4930-351-14
0077 00
ASSEMBLY
NOTE
During assembly, apply a light coating of petrolatum to O-Rings before installation.
1.
Install locking pin (16) and spring (17).
2.
Install lugs (13 and/or 14) and screws (15).
3.
Install bumper (12) with the thin lip seal end facing away from the 2-inch non-valved unisex coupling (3).
4.
Attach cable (10) to dust cap (8) by looping about 6 inches of cable (10) through the hole in dust cap (8) forming a loop
back on the cable (10). Install and crimp a sleeve (18) over the two sections of cable (10).
5.
If cable (10) was cut, attach cable (10) to split ring (11) by looping about 6 inches of cable (10) through the split ring
(11) forming a loop back on the cable (10). Install and crimp a sleeve (18) over the two sections of cable (10). If cable
(10) was not cut, attach to split ring (11) by rotating split ring (11) through the cable (10) loop.
6.
Install screen assembly (9) in 2-inch non-valved unisex coupling (3).
7.
Install spring (7) in 2-inch non-valved unisex coupling (3).
8.
Install dust cap (8) on 2-inch non-valved unisex coupling (3).
9.
Install O-Ring (5) and 2-inch non-valved unisex coupling (3) on D-1 nozzle inlet adapter (6).
NOTE
When inserting balls in unisex coupling ball race, use caution to avoid dropping loose
balls. Recommend working over a container.
10. Hold unit over a suitable container with screw hole facing up and adjust position until ball race (rounded groove) is
centered under ball retaining screw (1) hole. Install balls (4) one at a time, rotating 2-inch non-valved unisex coupling
back and forth until all 41 balls (4) have been inserted.
11. Install O-Ring (2) and ball retaining screw (1) in 2-inch non-valved unisex coupling (3). Tighten ball retaining screw
(1).
END OF WORK PACKAGE
0077 00-3/4 blank