TM 10-4930-351-14
0083 00
NOTE
Assure guide shaft is in hole in machine screw.
7.
Align notch in cover (2) with hole in flanged area of pressure control body and place cover (2) on pressure control.
8.
Install nuts (3) on studs (4) and tighten nuts in crossing pattern to 20 foot-pounds (2.77 m-kg) torque.
9.
Insert plug (1) in cover.
STOP CYCLING VALVE ASSEMBLY REMOVAL AND DISASSEMBLY (Refer to figure 2.)
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanic Automotive
Shop Equipment, Automotive Maintenance and
Repair: Organizational Maintenance Common No. 1
1.
Hold ring (1) in place and remove capscrews (2).
2.
Remove ring and cover (3) from pressure control.
3.
Grasp button (4) and twist and pull until cycling valve assembly is removed from pressure control.
4.
Invert pressure control over drip pan and drain all residual fuel.
5.
Remove O-rings (5) from valve body (6). Discard O-rings.
6.
Apply pressure on spring (7) with washer (8) and remove retaining ring (9) from valve body (6).
7.
Remove retaining ring (10) from cycling valve stem (11) and remove valve body (6) from cycling valve stem (11).
8.
Remove washer (8) and spring (7) from cycling valve stem (11).
9.
Remove O-rings (12) from cycling valve stem (11). Discard O-rings.
10. Remove setscrew (13) from button (4), and remove button (4) from cycling valve assembly.
0083 00-3