TM 10-4930-351-14
0109 00
INSTALL TIMING (PULLEY END) COVER (Refer to Figure 13.)
INITIAL SET-UP:
Tools:
Materials/Parts Required
Socket, Hex Driver, 6 mm
Equipment Condition:
Camshaft installed
1.
Insert new oil seal (1) in timing cover (2).
2.
Attach new timing cover gasket (3) to crankcase (4).
NOTE
Two stator wire clamps are attached to timing cover with two of the ten cap screws attaching
timing cover. These two cap screws and flat washers do not need to be torqued down until the
procedure attaching the stator to timing cover. The two screws are located at the 5 and 6 o'clock
positions of the timing cover.
Install the eight socket head cap screws (5) attaching timing cover (2) to crankcase (4). Torque to 190 to 195 in. lbs. (21-
3.
23 Nm). Install and hand tighten two cap screws (6) and flat washers (7).
4.
Attach crankcase breather hose (8) to timing cover (2).
8
5
4
2
3
1
6
7
7
6
Figure 13. Timing Cover Installation
0109 00-17