TM55-1500-345-23
CODE
DIRECTIONS
WORDING
NO.
Locate at station 173 an right side of helicopter
55
which has had heater exhausts relocated to this
position. Stencil the Words "DANGER EXHAUST"
on the stiffner securing the wire cover. The wire
cover and stiffner will be the some color as the
adjacent surface. Use 1/4-in. black letters.
56
a. Right side of toil boom, AFT of elevator. 1/4
MAX. ELEV. NOSE DOWN
inch letters "Rivet P". Paint rivet head same color
as adjacent surface. The arrow will point to the
specific rivet for travel.
b. Right side of tail boom, AFT of elevator. 1/4
FULL AFT CYCLIC STICK
inch letters "Rivet S". Arrow 1/2 inch long, 1/8
inch shaft, pointing down. Paint rivet head same
color as adjacent surface. The arrow will point to
the specific rivet for travel.
FULL FWD CYCLIC STICK
c. Right side of tail boom, AFT of elevator. 1/4
inch letters "Rivet R". Paint rivet head same color
as adjacent surface. The arrow will point to the
specific rivet for travel.
Right side of tail boom aft of 42 gear box
57
REMOVE TO SERVICE WITH
cover 1/2-in. black letters.
M I L - L - 2 3 6 9 9 OIL ABOVE 25F
MIL-L-7808 OIL BELOW -25 F
Right side of aircraft directly below 90 gear
58
SERVICE GEAR BOX
box and 4 in. above ARMY, 1/2-in. black
MIL-L-23699 ABOVE -25 F
letters.
MIL-L-7808 BELOW - 25 F
Right side of fuselage, 1/4-in. black letters,
59
TRANS OIL
LIGHT SWITCH
above switch.
Paint 1 in. wide black stripe 10 in. long above
60
center of kick-in doors. Both sides of
aircraft.
Locate right aft lower corner of cowl door,
61
ENGINE OIL TANK INSIDE
1/2-in. black letters.
MIL-L-23699 ABOVE -25 F
MIL-L-7808 BELOW - 25 F
(Sheet 12 of 17)
Figure 9-30. Exterior Markings, UH-1C and UH-1M
9-145
Change 1
