TM55-1500-345-23
CODE
DIRECTIONS
WORDING
NO.
Paint vertical black stripe above center of
11
upper forward kick-in doors.
Both sides of aircraft on upper kick-in doors,
12
ACCESS FOR FIRE
3 places, 1/2-in. black letters.
EXTINGUISHER
STEP
13
Paint a vertical black stripe above center of
upper aft kick-in doors.
UH-1M. Left side of fuselage 1/2 inch, Black
14
letters (See MIL-C-83413/9-2 for dimensions).
Paint a 2 in. wide black stripe over top of
15
cowling to show turbine wheel location and
stop the line at the bottom of the cowling.
Location will be 10-1/2 inches forward from
rear cowling.
Locate on access door left side of exhaust
DRIVE SHAFT
16
fairing and drive shaft cover, 3 places. 1/2
ACCESS
inch black letters.
17
Locate below access door, code No. 16, 1/2-
ELECTRICAL DISCONNECT
in. black letters.
ACCESS
18
Locate below access door, and code Nos. 16
TAIL BOOM MOD
and 17, 1/2-in. black letters.
PLATE INSIDE
19
Locate on access doors, both sides of air-
DIRECTION CONTROL
craft, 1/4-in. black letters.
PULLEY ACCESS
Locate inside of drive shaft covers above
20
INSTALL SHAFT CLAMP
couplings. 1/2-in. black letters.
INDEXED 90 TO EACH OTHER
TORQUE TO 30-35 IN-LB
(Sheet 7 of 17)
Figure 9-30. Exterior Markings, UH-1C and UH-1M
9-140
Change 1
