TM 55-1500-345-23
CODE
NO.
DIRECTIONS
WORDING
A 1/2-in. diameter red dot on pitch horn and on
32
upper and lower surface of blade and grip and
attaching linkage.
33
A 1/2 in. diameter white dot on pitch horn and
on upper and lower surface of blade and grip
and attaching linkage.
Authorized placement of unit insignia is on the
34
nose access panel.
Right side center, oil cooler compartment
BATTERY ACCESS
access door or nose aircraft center of avionics
compartment cover, depending on aircraft con-
figuration. 1/2-in. black letters.
36
Nose of aircraft on access door, 1/2-in. black
RADIO ACCESS
letters.
Two places on nose of helicopter at battery
37
BATTERY VENT
vents. 1/2 in. black letters.
Bottom of fuselage, left side, top of letters to
38
HYD PUMP DRAIN
aircraft centerline. 1/2-in. black letters.
I
Locate on both sides of fuselage directly above
CROSS TUBE
front cross tube, 1/4 in. black letters
MOORING LOAD
NOT TO EXCEED
FWD
2600 LBS VERT DN
5000 LBS FORE & AFT
Tail rotor control markings will be with 1/2-in.
dots located in conspicuous place on each part.
Colors red and white. One side shown, opposite
side of assembly will have 1/2-in. white dots in
the same location.
Figure 9-37. Exterior Markings, UH-1D and UH-1H
(Sheet 12 of 17)
Change 8
