TM 55-2840-231-23
6-20. Power Turbine Governor - Installation
Applicable Configuration
All
Consumable Materials
Grease (item 37, Appendix D)
Antiseize Compound (item 6, Appendix D)
References
Para 1-63 thru 1-71 and 6-3
When removing or installing fittings
in the governor, be careful not to
cause a load on the drive shaft.
If a new governor is to be installed,
transfer the tube fittings from the
removed governor to the new gover-
nor. Use new preformed packings;
do not lubricate. Do not tighten
jam nuts. Tighten nipples to 75-110
in. lb (0.9 -1.3 kg/m).
POWER TURBINE
GOVERNOR/
1. Drive Shaft
ENGINE/
Grease (item 37, Appendix D)
Antiseize Compound (item 6,
Appendix D).
Coat governor drive
shaft splines with lubri-
cant and the studs with
antiseize compound.
Do not lubricate tube
fittings.
Install governor on
mounting pad studs.
Make certain governor
drive splines are properly
engaged in gearbox
drive splines, the
governor must be flush
against gearbox mount-
ing pad.
6-45
