TM 55-2840-231-23
6-22. Power Turbine Governor - Preparation For Storage and Shipment
INITIAL SETUP
Applicable Configuration
Consumable Materials
All
Drycleaning Solvent (item 1, Appendix D)
Corrosion Preventive Compound (item 11,
Appendix D)
Tape (item 3, Appendix D)
Barrier Material (item 2, Appendix D)
References
Para 1-39, 2-7 and 2-20
NOTE
The procedure for removing the
power turbine governor from the
metal shipping and storage con-
tainer is prescribed in the applicable
provisions of paragraph 2-20.
Prepare the power turbine governor for stor-
age, shipment, and installation in a metal
shipping and storage container, MS27684-2,
as follows:
Use extreme care to prevent foreign
material from entering the pneumatic
tubes or the governor ports.
a. Install shipping plugs
in all ports to prevent
entry of foreign material.
Drycleaning solvent, P-D-680, used
to clean parts is potentially dangerous
to personnel and property. Avoid
repeated and prolonged skin con-
tact. Avoid prolonged or repeated
breathing of vapors. Do not use near
open flame or excessive heat. Flash
point of solvent is 100°F - 138°F
(38°C - 59°C).
6 - 5
2
