TM 55-2840-231-23
8-2.
0il Filter Housing - Removal and Installation
INITIAL SETUP
Applicable Configuration
Consumable Materials
All
Lubricating Oil (item 5, Appendix D)
ENGINE/
1. Oil Filter Housing
Removal
a. Remove eight self-locking
nuts (1) and washers (2).
Disengage clamp (3) from
the stud at the RH side
of the housing (if installed).
b. Lift housing (4) out of
the gearbox.
Discard gas-
ket (5).
c. Remove check valve (7).
Discard preformed packings
(6) and (8).
d. Remove preformed pack-
ings (9 and 10) from oil
tubes (11 and 12) and
discard preformed packings.
8-2
