TM 55-2840-231-23
8-2. Oil Filter Housing - Removal and Installation - Continued
ENGINE/ - Continued
Prolonged contact with lubricating oil
(item 5, Appendix D) may cause a skin
rash. Those areas of skin and clothing
that come in contact with lubricating
oil should be thoroughly washed imme-
diately. Enclosed areas where lubricating
oil is used should be adequately ventilated
to keep mist and fumes to a minimum.
2. Installation
Lubricating Oil (item 5, Appendix D).
a. Lubricate new preformed
packings (9 and 10) with
oil and install on oil tubes
(11 and 12) and install
on check valve (7). Install
the check valve in the
gearbox.
b. Place new gasket (5) on
the gearbox.
c. Insert housing (4) into
the gearbox and engage
the mounting studs. Insure
that the housing is mated
with oil tubes (11 and 12)
and with check valve (7).
d. T63-A-700 only. If the
engine has an auto reigni-
tion system installed,
place tube clamp (3) on
the stud at the RH aide
of the housing.
e. Retain the oil filter
housing with eight washers
(2) and self-locking nuts
(l). Tighten the nuts
to 35-40 in. lb (0.4-.5
kg/m).
8-3
