TM55-2840-251-23
2-1 AIR INLET SCREEN (Continued)
2-1-5 INSTALLATION
CAUTION
When air inlet screen is removed, keep
intake area clear of all foreign objects which
could be ingested by engine and cause
serious internal damage. If object is
dropped inside ducting, cease all removal or
installation
procedures
until
object
is
located and removed.
1. Smear chafing strips with Petrolatum (E.20).
2. Install air inlet screen on compressor inlet case, insuring
locating dowel (7) fits into associated hole on rear fireseal
mounting ring.
3. Secure flanges, at 6 o'clock position, as follows:
a. Install bolt (3), with washer (2), through aft bolt
holes. Secure with second washer (2) and nut (1).
b. Install bolt (3) through fuel pressure tube bracket
(6) and center bolt holes. Secure with washer (2) and nut
(1).
c. Install bolt (3) through ignition harness loop
clamp (5), through front bolt holes and second loop clamp
(5). Secure with washer (2) and nut (1).
d. Torque nuts to 36 to 40 inch-pounds.
FOLLOW ON MAINTENANCE:
None
END OF TASK
2-7/(2-8 blank)
