TM55-2840-251-23
6-1 FUEL CONTROL ASSEMBLY (Continued)
6-1-1 REMOVAL
1. Remove cotterpin (1), castellated nut (2), washer (3)
and bolt (4) securing control rod (5) to fuel control unit
actuating arm.
2. Remove lockwire and disconnect air pressure line (6)
and fuel inlet hose (7).
3. Remove lockwire and disconnect fuel delivery tube
(8 and air pressure tube (9).
4. Remove four nuts (10) and plain washers (11)
securing fuel control unit (12) to fuel pump.
Remove control unit.
5. Remove and discard preformed packing (13).
6. Remove/replace coupling (14 if necessary.
NOTE
Coupling may remain attached to fuel
control unit.
7. If fuel control unit is to be replaced, loosen locknuts
(15), and remove elbow assemblies (16).
8. Remove and discard preformed packings (18) and
backup rings (17).
9. Cap all exposed orifices an tubes.
GO TO NEXT PAGE
6-4.1/(6-4.2 blank)
