TM55-2840-251-23
6-1 FUEL CONTROL ASSEMBLY (Continued)
6-1-3 INSTALLATION (Cont)
10. Connect air pressure line (6) to 45 degree elbow on
fuel control unit. Torque connector to 90 to 100 inch-
pounds and lockwire (E.5).
11. Connect internally threaded control rod (5) to fuel
control actuating arm and secure with bolt (4), plain
washer (3) and castellated nut (2). Torque nut to 20 to
30 inch-pounds, aligning locking hole within these
limits. Lock with cotterpin (1).
CAUTION
If fuel control assembly has been
replaced, preservation oil must be
removed.
6-1-4 ADJUSTMENTS
Adjustments shall be performed at Testing only
(Chapter 1, Section X).
FOLLOW ON MAINTENANCE:
Test in Accordance with
Chapter 1, Section X
END OF TASK
6-7/(6-8 blank)