TM 55-2840-254-23
2-30 INSTALL STATOR VANE ASSEMBLIES (Continued)
2-30
NOTE
The following procedure applies to the first thru
seventh stage stator vane assemblies. First
stage stator vane assembly is shown.
8. Inspect for clearance between stator vane
shrouds as follows:
a. Apply non-lead gear marking compound
(E38.1) to both ends (34) of stator vane
shroud (35) on installed compressor housing
half (36). Use acid swabbing brush (E2).
GO TO NEXT PAGE
Change 5
2-251