TM 55-2840-254-23
2-30 INSTALL STATOR VANE ASSEMBLIES (Continued)
2-30
Apply non-lead gear marking compound
(E38.1) to both ends (37) of stator vane
shroud (38) on removed compressor housing
half (39), Use acid swabbing brush (E2).
Temporarily install removed compressor
housing half (Ref. Task 2-24, steps 1. thru 3.
or Task 2-25, steps 1. thru 3.).
Remove temporarily installed compressor
housing half (Ref. Task 2-19, steps 29. thru
32. and 38. or Task 2-20, steps 35. thru 38.
and 48.).
Inspect both ends (37) of stator vane shroud
(38) of removed compressor housing half (39).
There shall be no non-lead marking com-
pound.
f. If no non-lead gear marking compound is
visible, clearance is acceptable.
g. Wear gloves (E20). Use dry cleaning solvent
(E17) and brush, clean off all non-lead marking
compound. Wipe dry using lint-free cloth
(E26).
h. If non-lead gear marking compound is visible,
proceed as follows:
(1)
(3)
Loosen stator vane mounting bolts, shift
stator vane and retorque mounting bolts
(Refer to steps 1 thru 7).
Repeat steps 8.a. thru 8.e.
If non-lead gear marking compound is still
visible, proceed as follows:
GO TO NEXT PAGE
2-252
C h a n g e 5
