TM 55-2840-254-23
2-7 INSTALL INTERSTAGE AIR-BLEED ACTUATOR (WITHOUT WATER WASH KIT
2-7
P/N 2-200-071-54 INSTALLED) (Continued)
5. Position piston assembly (5) so hole (12) can be
seen through slot (6). Install pin (13), washer
(14), and cotter pin (15).
6. Install on compressor housing. Secure with
two bolts (16) and eight bolts (17). Torque two
top bolts (16) to ten inch-pounds, Torque
remaining eight bolts (17) in pairs, 180
degrees apart, in rotation to 20 inch-pounds
initial torque. Retorque same eight bolts (17)
in same sequence to 35 to 40 inch-pounds.
Lockwire ten bolts (16 and 17). Use Iockwire
(E29).
GO TO NEXT PAGE
2-24 Change 5
