TM 1-1500-204-23-1
·
Personnel restraining harness (gunner and
hoist operator)
·
Safety belts (airline type)
·
Inertia reel strap (webbed strap only)
·
Leg restraints
·
Litter straps
NOTE
·
Safety belts will not be replaced
for cosmetic reasons.
·
Safety
belts
having
cotton
webbing are to be removed from
service.
·
Replace
loose,
missing,
or
damaged bolts, nuts, washer,
and shims in the anchoring
points.
(1) Spring webbing retarder. Replace spring
webbing retarder used in shoulder harness and seat belt
webbing adjusters as follows:
(a) For shoulder harness webbing adjuster,
P/N MS22007, use spring, P/N 65D34083-7 and the
following procedures
1
Hook one end of webbing retarder
spring around flat end of knurled locking bar as shown in
figure 11-7.
2
Cut a 16-inch length of type 1
nylon cord, and tie the loose ends together to form a
loop in the cord.
3
Insert the nylon cord loop through
the slot of the adjuster plate, and hook loop over the
webbing retarder
spring hook end.
4
Pull
the
nylon
cord
through
adjuster plate slot and around the bar.
Figure 11-7. Shoulder Harness Webbing Retarder Spring Installation
11-23
