NAVAIR 01-1A-505-2
006 04
TO 00-25-255-1
Page 2
TM 1-1500-323-24-2
enhance its operational characteristics. These
Support Equipment Required
accessories are divided into the following categories:
Part No./
Nomenclature
a.
Backshells.
Type Designation
BT-BS-601
Wrench, Strap
b.
Connector Assembly Tools.
BT-BS-609
Wrench, Strap
BT-ES-611
Wrench, Strap
c.
Dummy Receptacles.
BT-BS-618
Wrench, Strap
BT-BS-625
Wrench, Strap
d.
Dust Caps.
BT-BS-630
Wrench, Strap
BT-HT-107
T-handle
e.
Shrink boots and Adapters.
CM-S-264
Set, Adapter
CM-S-264R
Set, Adapter
f.
Conduit Fittings.
CM-S-5015
Set, Adapter
CM-8-5015R
Set, Adapter
g.
Dummy Receptacles.
CM-8-837
Set, Adapter
CM-S-837RB
Set, Adapter
h.
Dust Caps.
Materials Required
i.
Gaskets for Flange Mount Receptacles.
Specification/
Nomenclature
j.
Mounting Nut for Jam Nut Receptacles.
Part No.
A-A-52080 thru A-A-52084 Tape, Lacing
k.
Rubber Bushings.
P-2740FR
Tape, Silicone Rubber
4529670544
Tape, Silicone Rubber
l.
Sealing Plugs.
1. INTRODUCTION.
4. BACKSHELLS. Backshells are the most complex
connector accessories and simply stated they are any
2. This Work Package (WP) covers connector
device added to rear or wiring side of a connector.
accessories used with MIL-DTL-83723 series
Backshells may be divided into the following categories:
connectors, their function, associated tools, assembly,
and procurement information.
a.
Grommet Nuts.
NOTE
b.
Cable Clamps and Strain Reliefs.
As all NAVAIR connector and accessory
c.
EMI/RFI Grounding Terminators.
documents are transitioned to non-government
standards, the Society of Automotive Engineers
d.
Non-Environmental Backshells.
(SAE) will become the preparing activity and
the Navy will adopt the documents, and the
e.
Environmental Backshells.
drawing number prefix will change from MS
to AS. The main part number designation
f.
Non-Environmental EMI/RFI Backshells.
remains the same, with the "M" prefix, such as
M81511/17-08. At times the entire item may be
g.
Environmental EMI/RFI Backshells.
superseded by another. There are many cases
where documents have been cancelled without
5. MIL-DTL-83723 SERES II AND III CONNECTOR
replacements, each case was reviewed and
ACCESSORIES.
some information has been retained in this
volume "for reference use only".
6. SPECIAL TOOLS. Connector backshells come in a
wide variety of types depending on application. To
3. C O N N E C T O R A C C E S S O R I E S . C o n n e c t o r
install backshells or accessories, adapter tools and a
accessories are components added to a connector to
strap wrench are needed. Adapter tools (Figure 1) are
used to hold connector during backshell installation
