NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
007 02
1 September 2011
Page 3
Series Designation.............................................................................................................................................. 21
Shell Designation ............................................................................................................................................... 21
Specification Sheet............................................................................................................................................. 21
Polarization ............................................................................................................................................................. 14
Power Contacts ....................................................................................................................................................... 22
Shell ........................................................................................................................................................................ 14
Tooling.................................................................................................................................................................... 22
Record of Applicable Technical Directives
None
7.
INTRODUCTION
Support Equipment Required
8. This Work Package (WP) covers two series of
Part No./
electrical, rectangular connectors with crimp type
Type Designation
Nomenclature
removable contacts. These connectors are provided
with single, dual, triple, and quadruple insert shell
HT-900B ............................................... Heating Tool,
configurations.
(or equivalent)
Compressed Air
9. DESCRIPTION. The following paragraphs
M22520/1-01 ................................ Crimp Tool, Frame
cover SAE AS81659 connector classifications.
M22520/1-02 ............................................... Positioner
M22520/1-11 ............................................... Positioner
10. Types. There are four types for these connectors
M22520/2-01 ................................ Crimp Tool, Frame
and are as follows:
M22520/2-08 ............................................... Positioner
M22520/2-11 ............................................... Positioner
a.
Type I - Short grommet seal (Series 1 only)
M22520/2-23 ............................................... Positioner
M22520/7-01 ................................ Crimp Tool, Frame
b.
Type II - Standard grommet seal
M22520/7-02 ............................................... Positioner
M22520/7-03 ............................................... Positioner
c.
Type III - Without grommet seal
M81969/1-01 ................................. Tool, Insertion and
Removal
d.
Type IV - Without interfacial and grommet
M81969/1-02 ................................. Tool, Insertion and
seals
Removal
M81969/1-03 ................................. Tool, Insertion and
11. Class Description. These connectors have two
Removal
classifications according to operating environment:
M81969/14-01 ............................... Tool, Insertion and
Removal
M81969/17-01 ......................................Tool, Insertion
M81969/19-01 ..................................... Tool, Removal
M81969/28-02 ..................................... Tool, Removal
This document includes cadmium as a
Materials Required
plating material. The use of cadmium has
been restricted and/or banned for use in
Specification/
many countries due to environmental and
Part No.
Nomenclature
health concerns. Consult applicable health
an environmental regulations regarding its
TT-I-735 Alcohol, ....................................... Isopropyl
use, handling and disposition.
SAE-AMS-I-23053 ..................... Insulating Sleeving,
Heat Shrinkable
a. Class 1: -85F (-65C) to +237F (+125C),
MIL-F-14256 (or equivalent) .................. Flux, Liquid
Material: Aluminum, Cadmium plated.
SnGOWRMAP3 (or equivalent) .......................Solder