NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
007 02
1 September 2011
Page 5
Table 1. Wire Sizes and Diameters
Finished Wire Outside Dimensions
Contact
Wire Size
Size
(AWG)
Minimum
Maximum
Inches
MM
Inches
MM
22
26, 24, 22
.030
0.76
.054
1.37
20
24, 22, 20
.040
1.02
.071
1.80
16
20, 18, 16
.068
1.73
.103
2.62
12
14, 12
.097
2.46
.135
3.43
9. Specification Sheet. The specification sheet will
NOTE
denote how many inserts, environmental, non-
environmental, and type of class.
As all NAVAIR connector and accessory
documents are transitioned to non-
10. Shell Designation. The shell designation will
government standards, (the Society of
consist of a letter identifying a keystone or
Automotive Engineers (SAE), will become
rectangular insert.
the preparing activity and the Navy will
adopt the documents), the drawing number
11. Series Designation. The series designation will
prefix will change from MS to AS. The
consist of a one digit number to determine front or
main part number designation remains the
rear release contact.
same, with the "M" prefix, such as
M81511/17-08. At times the entire item
12. Insert Designation. The insert designation shall
may be superseded by another.
consist of a four digit number (Table 2, Figure 2).
There are many cases where documents
have been cancelled without replacements,
each case was reviewed and some
information has been retained in this
volume "for reference use only".