NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
008 02
1 September 2011
Page 16
F.
Tin Center Conductor And Solder Onto Center Contact. Maintain A
Butt Condition Between Contact And Dielectric While Soldering In
Place.
Dielectric Bushing
Crimp Sleeve
Center Contact
G. Insert Center Contact Assembly Into Contact Outer Body Until It
Bottoms. If Previously Installed. Slide Metal Gap Onto Outer Contact
Ferrule Until It Bottoms.
Crimp Sleeve
Outer Body
Approximately
H . Fold Outer Conductor Strands Evenly Over Ferrule End Of Outer
1/16 Inch
Contact Body And Metal Cap, If Installed, And Position Crimp Sleeve
Over Them Approximately 1/16 Inch From Contact Should e r .
Figure 8. Coaxial Cable and Shielded Contact Assembly (Sheet 2)
43. CONNECTOR BUILDUP.
45. CONTACT CRIMPING. Crimp contact in
accordance with following procedure:
44. WIRE STRIPPING. Strip wire in accordance
with following procedure:
a.
Select correct crimp tool (Table 4, 6 or 7).
a. Cut wire to proper length. Ensure enough
b. Perform die closure check, install positioner,
wire remains for adequate strain relief without
and set selector knob for gage of wire (NAVAIR 01-
leaving excess slack.
1A-505-1, WP 013 00).
b. Strip insulation from end (NAVAIR 0l-1A-
c. Insert stripped wire into contact conductor
505-1, WP 016 00). Select contact (Table 3).
barrel. Ensure all wire strands are inside contact
conductor bane1 and visible in contact inspection
hole (Figure 9).
