TM 1-1510-262-10
(7) Right upper cowl locks -- Locked.
(8) Right exhaust stack -- Check for cracks and free of obstructions.
(9) Engine compartment, right side -- Check for fuel and oil leaks and condition. Check door secure.
e. Left wing center section -- Check.
* (1) Auxiliary tank fuel, cap, and sight gauge -- Check fuel level visually, condition of seal, and cap
tight and properly installed.
(2) Heat exchanger inlet and outlet -- Check for cracks and free of obstructions.
(3) Deice boot -- Check.
* (4) Auxiliary tank fuel sump drain -- Check for leaks.
(5) Hydraulic reservoir vent and pump seal drain -- Check vent clear of obstructions, and that no
excessive luid is present.
(6) Monopole antenna -- Check condition.
f. Fuselage underside -- Check.
* (1) General condition -- Check for skin damage.
(2) Antennas -- Check security and condition.
2. Nose Section. Check as follows:
a. Nose section Check.
* (1) General condition -- Check.
(2) Free air temperature probe -- Check condition.
(3) Avionics door, left side -- Check secure.
(4) Air conditioner exhaust -- Check free of obstruction.
(5) Data link antenna radome -- Check condition.
(6) Forward left EOMS -- Check condition.
(7) Wheel well condition -- Check for signs of leaks, broken wires, and condition.
(8) Doors and linkage -- Check.
(9) Nose gear turning stop -- Check condition.
* (10) Shock strut -- Check for signs of leakage and 3.0 inches minimum extension.
(11) Torque links -- Check condition.
* (12) Tire -- Check condition.
(13) Shimmy damper and linkage -- Check.
(14) Landing and taxi lights -- Check for security and condition.
(15) Pitot tubes -- Check free of obstruction.
(16) WX Radome -- Check condition.
(17) Windshields and wipers -- Check.
(18) Forward right EOMS -- Check condition.
(19) Air conditioner inlet -- Check free of obstructions.
(20) Avionics door, right side -- Check secure.
3. Right Wing Area. Check as follows:
a. Right wing center section -- Check.
* (1) Auxiliary tank fuel, cap, and sight gauge -- Check fuel level visually, condition of seal, and cap
tight and properly installed.
(2) Battery access panel -- Secure.
(3) Battery exhaust louvers -- Check free of obstructions.
(4) Heat exchanger outlet and inlet -- Check for cracks and free of obstruction.
(5) Deice boot -- Check.
(6) Battery compartment drain -- Check free of obstruction.
8-11