TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
SERVICE UPON RECEIPT
UNPACKING
1.
Open doors on all three (3) TRICON containers.
2.
Using a forklift, unload reusable crates from all TRICON containers.
3.
Remove top and end from each crate.
INSPECTION
1.
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the damage on
SF 364, Report of Discrepancy.
2.
Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in accordance
with the instructions of DA PAM 738-750.
PREPARATION FOR USE
Pump-Engine Module
1.
Before placing in service, clean all unpainted surfaces with MIL-PRF-680 (WP 0116, Item 13).
2.
Check level of oil in engine crankcase. Add up to 1.9 qt (1.8 l) SAE 15W-40 lubricating oil (WP 0116, Item 17) to the
3.
Add fuel (JP8) to fuel tank.
4.
Install air filter on intake manifold.
Accessory Module
1.
Open battery compartment cover and remove all wrapping from battery cable connectors.
2.
Connect battery cables to battery terminals.
3.
Start and run engine for several minutes, checking for oil leaks. Repair any leaks before placing engine in service.
Fuel Drums
Fuel drums may contain some residual water from factory tests. Drain completely and ventilate well to ensure all moisture
has evaporated before first use.
END OF WORK PACKAGE
0017 00-1/2 blank