TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPLACE PUMPAGE OVERTEMPERATURE SENSOR/SENSOR CABLE (W103)
INITIAL SET-UP:
Materials/Parts Required:
Tools:
Rags, Wiping
Tool Kit, General Mechanics
Sealant, Thread, LH-150
Drain Pan
Electrical Tape
Tester, Thermostat
TEST SENSOR CABLE ASSEMBLY
NOTE
The following sensor cable test procedure shall be successfully completed prior to
deployment, with the engine operating.
1.
Disconnect the connector to 1A1J3 receptacle (1).
2.
The engine should shut down.
3.
"PUMPAGE HOT" indicator light on the control panel should illuminate.
4.
If 2 or 3 do not occur, repair unit before deployment.
3
2
1
0022 00-1