TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPLACE AUXILIARY PUMP ROTOR VANES
INITIAL SET-UP:
Materials/Parts Required:
Tools:
Tool Kit, General Mechanic Automotive
Chemical and Oil Protective Gloves
Equipment Condition
Auxiliary pump module defueled
WARNING
Death or personal injury may result from the explosion of fuel fumes exposed to an open
flame or spark, or to static discharge. Do not permit smoking, any open flame, or spark
producing equipment within fifty (50) feet (15.24 m) of the auxiliary pump during repair.
Rubber gloves should be worn when handling fueling system components due to the toxic
effects of some fuel additives.
NOTE
Even with the auxiliary pump defueled, some residual fuel may remain due to normal drainage
Inspect all components as they are disassembled. Repair is limited to replacement of unserviceable
components discovered during disassembly.
DISASSEMBLY AND INSPECTION
1.
2.
Remove four bolts (1) that attach pump rotor cover (2). Remove cover (2).
3.
Remove and discard rotor cover gasket (3).
NOTE
A new pump rotor vane is 7/16 in. high. Replace vane if height is 9/32 in. or less. A vane
that does not make good contact with pump chamber will cause loss of suction.
4.
Remove the five vanes (4) from rotor (5). Inspect vanes (4) for damage and wear.
5.
Remove rotor key (6). Inspect for damage or deformation. Replace if damaged or deformed.
6.
Remove rotor (5). Inspect for damage. Scratches will not affect the rotor; however, burrs should be removed.
0073 00-1