TM 10-4930-351-14
0109 00
Refer to Figure 2.
NOTE
The rear crankshaft bearing oil passage hole must be aligned with matching oil holes on
crankcase during installation.
7.
Using bushing extractor tool, carefully install front crankshaft bearing (1) into flywheel end of crankcase (2).
2
1
Figure 2. Front Crankshaft Bearing Installation
Refer to Figure 1.
8.
Install crankshaft (3) in crankcase using center bearing mounting tool to match hole in crankcase with hole in center
bearing support. Install center bearing support retaining screws (5) and flat washers (6).
9.
Torque center bearing support retaining screws (5) to 190 to 195 in. lbs. (21-23 Nm).
Refer to Figure 3.
NOTE
Alignment of rear main bearing oil passage hole and rear crankshaft support oil holes
must be maintained during installation of rear main bearing.
10. Align rear main bearing (1) oil passage hole (2) with rear crankshaft support (3) oil holes. Using bushing extractor tool,
install engine rear main bearing (1) in rear crankshaft support (3).
11. Install rear engine oil seal (4) in rear crankshaft support (3).
12. Install O-ring (5) on rear crankshaft support (3).
0109 00-3