TM 10-4930-351-14
0109 00
INSTALL FUEL INJECTOR (Refer to Figure 24.)
INITIAL SET-UP:
Tools:
Materials/Parts Required
Socket, Socket Wrench, 13 mm
Combination Wrench, 10 mm
Equipment Condition:
Combination Wrench, 7 mm
Cylinder head installed
NOTE
Copper washers under fuel injectors are used to adjust injector protrusion into the
combustion chamber of cylinder head. If the old fuel injector is being installed, ensure
number of washers installed is the same number that was removed. If a new fuel injector
is to be installed measure the nozzle length of the old and new injectors, remove or insert
copper washers to adjust the protrusion of the new injector in the cylinder head to
achieve the same protrusion as with the old injector.
1.
Insert copper washer(s) (1) in cylinder head.
2.
Install and tighten union bolt (2), union (3) and copper washers (4 and 5).
3.
Position fuel injector (6) in cylinder head.
4.
Install and tighten brace (7), washer (8) and nut (9) on mounting stud (10).
5.
Install and tighten fuel supply line (11) on fuel injector.
0109 00-32