TM 10-4930-351-14
0109 00
INSTALL FUEL FLOW SOLENOID (Refer to Figure 28.)
INITIAL SET-UP:
Tools:
Materials/Parts Required
Socket, Socket Wrench, 5 mm
Gasket (WP 0117 00, Item 46)
(WP 0113 00, Item 3)
O-Ring (WP 0117 00, Item 56)
Ratchet Wrench, 3/8 in. Drive
Copper Washers (WP 0117, Item 61)
(WP 0113 00, Item 3)
Extension, 6 in., 3/8 in. Drive
Equipment Condition:
(WP 0113 00, Item 3)
Fuel injectors installed
1.
Insert O-ring (1) in crankcase.
NOTE
When the solenoid is installed in the crankcase, ensure solenoid arm is positioned to the
right of the control rod center lever arm.
2.
Hold control rod (2) center lever arm (3) fully to the left, position solenoid (4) on crankcase and install two socket head
screws (5) to attach solenoid to crankcase. Release control rod (2) and verify that solenoid arm (6) is to the right of the
control rod center lever arm (3).
NOTE
Copper washers are used under the two socket head cap screws at the lower side of the fuel control cover.
3.
Loosely install the five socket head screws (7), flat washers (8), nut (9) and washer (10) to attach the fuel control cover
(11) and gasket (12) to the crankcase. (Fuel control cover (11) must be removed later for injector timing.)
0109 00-37
