TM 55-2840-231-23
3-7. Combustion Section - Installation-Continued
ENGINE/ - Continued
5. Seal Ring Assem-
Molykote (item 41, Appendix D).
Apply mol ykote to seal
blies (19 and 20)
ring assemblies (19 and
20) if they do not in-
corporate a previously
applied bonded lubri-
cant. Install the indivi-
dual components of seal
assemblies (19 and 20)
and compressor discharge
air tubes (18). On the
small end of air tubes
(18), position ring gaps
180 degrees apart with
gap of seal rings to the
outboard side of tubes
(18). On large end of
tubes (18), position
ring gaps 180 degrees
apart with the gap of
seal rings to the inboard
side of tubes (18).
6. Left-Hand Com-
pressor Discharge
Air Tube (18)
7. Right Hand
Compressor Dis-
charge Air Tube (18)
Installation Clamp No. 6799953.
Insert left-hand com-
pressor discharge air
tube (18 ) through fire-
wall shield, Compress
seal ring with the com-
pressor discharge air
tube-to-compressor
scroll installation clamp.
Mate air tube (18) with
compressor scroll, then,
remove installation
clamp .
Install in the same
manner used for in-
stalling the left-hand
tube above.
Change 6
3-19
