TM55-2840-251-23
6-11 FUEL LINES AND FITTINGS (Continued)
6-11-2 CLEANING
1.
Clean all tubes with Varsol (E.9) .
2. If hard-to-clean soils are encountered on rigid
stainless steel tubes, immerse tube in cold Turco Super
Carb (E.63) for 10 to 30 minutes, as required. After
soaking, thoroughly rinse in hot water at 150
to 200
F
(65
to 93
C). If it is necessary to remove cleaning
compound after rinsing, pressure wash tube with Varsol
(E.9).
WARNING
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air
toward yourself or another person.
Failure to comply could result in injury
to eyes or skin. In case of injury, get
medical attention.
3.
Thoroughly dry all tubes and fittings with filtered,
clean, dehydrated compressed air.
GO TO NEXT PAGE
6-50.1/(6-50.2 blank)
