TM 55–2840–254–23
5–56 Change 6
5–11 INSTALL ACCESSORY GEAR ASSEMBLY (AVIM)
5–11
INITIAL SETUP
Applicable Configurations:
All
Tools:
Powerplant Mechanic’s Tool Kit,
NSN 5180–00–323–4944
Technical Inspection Tool Kit,
NSN 5180–00–323–5114
Locating Bar (T1)
Alignment Pin (T2)
Wrench Pin Plate (T9)
Handling Tool (T18)
Torque Fixture (T46)
Torque Multiplier (T63)
Retaining Ring Pliers
Dial Indicator
Outside Micrometer Caliper Set
Mechanical Puller (T3)
Materials:
Acid Swabbing Brush (E2) (2)
Dry Cleaning Solvent (E17)
Gloves (E20)
Lint–Free Cloth (E26)
Gear Marking Compound (E38.1)
Parts:
Packings
Lockring
Shim
Personnel Required:
68B10 Aircraft Powerplant Repairer (2)
68B30 Aircraft Powerplant Inspector
References:
TM 1–2840–254–23P
Task 9–11
Task 2–67
Task 9–14
Task 2–72
Task 5–7
General Safety Instructions:
WARNING
Dry cleaning solvent (E17) is flammable
and toxic. It can irritate skin and cause
burns. Use only in well ventilated area,
away from heat and open flame. In case
of contact, immediately flush skin or
eyes with water for at least 15 minutes.
Get medical attention for eyes.
GO TO NEXT PAGE
