TM 55–2840–254–23
Change 6 5–57
5–11 INSTALL ACCESSORY GEAR ASSEMBLY (AVIM) (Continued)
5–11
NOTE
If original accessory gear is being installed
omit following steps 1 thru 18 and go to
step 19.
1.
Paint accessory inner bevel gear teeth
(1) with gear marking compound.
CAUTION
In following step, be sure electrical
cable does not get caught as accessory
gear assembly is installed. Failure to
comply could cause damage to wiring
which would result in improper indica-
tion of engine operation.
2.
Position electrical cable (3) through
accessory gear assembly (4) and
install accessory gear assembly
(4). Use four washers (5) and four
bolts (6) to temporarily hold accessory
gear assembly (4).
3.
Turn engine to vertical position with inlet
housing facing down.
a.
Wear gloves (E20). Use lint–free cloth
(E26) dampened in dry cleaning solvent
(E17).
b.
Wipe dry, using clean, dry lint–free cloth
(E26).
GO TO NEXT PAGE
