TM 55-4920-328-13
CAUTION
Ensure V-band clamp halves are
equally spaced when installed on
T55-L-11/712 model engine.
(11) On T55-L-11/712 model engines, remove dust
cover and install tailpipe assembly (18) with V-band
clamp (20). Tighten clamp to 40 + 5 inch-pounds
torque. Install dust cover on tailpipe assembly.
(12) On T55-L-7/7C model engines, install tee (8),
tube assembly (9), packing (10), reducer (11), filter (12),
packing (13), and nipple (14) as shown in figure 2-26,
detail B.
(13) On T55-L-11 model engines, install tee (8),
tube assembly (9), packing (10), reducer (11), filter (12),
packing (13), and nipple (14) as shown in figure 2-26,
detail A.
(13.1) On T55-L-712 model engines, install tee (8),
tube assembly (9), packing (10), reducer (11), filter (12),
packing (13), and nipple (14) as shown in figure 2-26,
detail G.
(14) Install packing (3), reducer (4), and hose
assembly (4A) (refer to table 2-9, connection point 36) in
engine oil pump discharge port.
(15) Install packing (5), union (6), and elbow (7) in
engine No. 2 bearing oil port.
(16) Install gasket (15) and pressure probe (16) in
engine combustor housing.
(17) Install elbow assembly (21), gasket (22),
customer air valve (30), and gasket (26).
(18) On T55-L-7/7C model engines, install adapter
assembly (31) and vibration pickup (32) on engine inlet
housing.
1.
(Deleted)
2.
Packing -STD3000E24
3.
Drive Assembly - 2-080-150-06
4.
Gasket- MS9134-01
5.
NIl Tachometer Generator - MS25038-4
5A.
Nut - AN960-416L (Engine Supplied)
5B.
Washer - AN960-416L (Engine Supplied)
6.
NI Tachometer Generator - MS25038-4
6A.
Nut - STD3064-4 (Engine Supplied)
6B.
Washer-AN960C416L (Engine Supplied)
7.
Gasket- MS9134-01
Figure 2-25. T55 Tachometer Generator Installation.
Change 4
2-106.1