TM 55-4920-328-13 2-34.  Installation of Fuel Control Slave Units. Install   the   slave   units   and   connect   to   fuel   control actuator linkage as shown on figure 2-27.  Adjustment of fuel control actuator linkage is contained in paragraph 2- 11. 2-35.  Test Trailer Hose and Cable Connections. Proceed as follows: a. Connect one end of hose assembly (1, figure 2- 33)   to   water   brake   aft   bearing   fitting   and   connect opposite end to portable oil unit OIL OUT port. b. Connect  one  end  of  hose  assembly  (2)  to  water brake air vent fitting; install reducer (3), packing (4), and coupler    (5)    in    opposite    end,    and    connect    to    AIR SUPPLY coupling on test trailer. c. Connect  one  end  of  hose  assembly  (6)  to  fuel inlet fitting; install reducer (7), packing (8), and coupler (9)   in   opposite   end,   and   connect   to   FUEL   SUPPLY coupling on test trailer. d. Connect   one   end   of   hose   assembly   (10)   to gearbox  vent  fitting.    Position  opposite  end  in  suitable overboard container. e. Connect   engine   starter   drain   hose   (11),   from hydraulic starter unit on test trailer, to case drain fitting. f. Connect engine starter oil return hose (12), from hydraulic starter unit on test trailer, to oil return fitting. g. Connect engine starter oil supply hose (13), from hydraulic starter unit on test trailer, to oil supply fitting. h. Connect one end of hose assembly (14) to water brake   oil   return   fitting;   install   reducer   (16)   and   tube assembly   (15)   in   opposite   end,   and   connect   to   OIL RETURN fitting on portable oil unit on test trailer. i. Connect   oil   collector   drain   hose   (17)   to   drain bottle assembly (18). j. Connect    hose    assembly    (19)    between    water brake  water  return  coupling  and  auxiliary  trailer  water return connection. k. Connect    hose    assembly    (20)    between    water brake   water   supply   coupling   and   WATER   SUPPLY coupling on test trailer. /. Connect   one   end   of   hose   assembly   (21)   to WATER  OUT  fitting  on  portable  oil  unit,  install  reducer (22), packing (23), and coupler (24) in opposite end, and connect to WATER RETURN coupling on test trailer. m.    Connect   one   end   of   hose   assembly   (25)   to WATER  IN  fitting  on  portable  oil  unit,  install  reducer (26), packing (27), and coupler (28) in opposite end, and connect to WATER SUPPLY coupling on test trailer. n. Connect   cable   assemblies   from   test   trailer   to data acquisition assembly as follows: 1. Connect W1 to J1 2. Connect W2 to J2 3. Connect W3 to J3 4. Connect W4 to J4 5. Connect W5 to J5 6. Connect W6 to J6 2-36.  Hydraulic Starter Hose Connections. Connect  hydraulic  starter  hoses  (11,  12  and  13)  to the starter in accordance with detail B, figure 2-33. 2-36.1 Test Engine. Test    the    engine    in    accordance    with    procedures specified in Chapter 3. 2-37.  Removal of Engine and Engine Test Dolly. Proceed as follows: NOTE When   removing   engine   accessories, reinstall   all   engine   plugs   and   dust covers. Change 4 2-127