TM 1-4920-438-13&P
0025 00
REMOVE
1. Remove two wing nuts attaching removable propylene ring to fixed propylene ring.
2. Place wing nuts in cotton mailing bag.
3. Remove two bolts with lock washers and flat washers attaching bracket to wall.
4. Place hardware in cotton mailing bag.
5. Remove two bolts, lock washer, flat washers, and nuts attaching ring assembly brace to angle bracket.
REPAIR
1. Prepare and weld cracked or broken welds in accordance with MIL-STD-2219. Welding repair must not
interfere with form, fit, or function of stand.
2. If propylene rings are bent, try to reshape by using the anvil horn and a steel hammer.
3. If single cylinder mod bracket assembly is damaged beyond repair, replace with a new one.
INSTALL
1. Attach ring assembly brace to angle bracket with bolts, lock washers, flat washers, and nuts obtained from
cotton mailing bag.
2. Mount single cylinder mod bracket assembly in its original location on wall using bolts, lock washers, and flat
washers obtained from cotton mailing bag.
3. Attach movable propylene ring to fixed propylene ring with two wing nuts obtained from cotton mailing bag.
0025 00-4
