TM 10-4930-351-14
0085 00
INSTALLATION
1.
Stretch the C-shaped seal (figure 2, 1) over the left-hand door's inside edge (2). Make sure seal is orientated so the large,
curved lip of the seal is on the outside portion of the door and extends over the end.
NOTE
Installation of the carriers must be complete before polyurethane is allowed to dry.
2.
Starting from the front about eight inches above the inside bottom edge of the left door, apply a 1/8 inch bead of
polyurethane sealant (figure 2, 3) down and along the C-shaped seal (1) to the end.
8 INCHES
2
1
1
OUTSIDE DOOR
3
2
1
Figure 2. Left-Hand Door C-Shaped Seal Installation
3.
Position long carrier (figure 3, 1) against the seal (2) on outside edge of door (3).
4.
Aline existing holes of long carrier (figure 3, 1) with existing holes on door (3) and drill a 3/16 inch hole through seal
(2) for the rivet at the two end holes on the long carrier (1).
5.
Install a rivet (4) in each end of long carrier (figure 3, 1).
6.
Repeat Steps (4) and (5) for center hole in long carrier (figure 3, 1).
7.
Repeat Steps (4) and (5) working from the center toward each end and install the remaining rivets (figure 3, 4).
0085 00-2