TM 10-4930-351-14
DIRECT SUPPORT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPAIR THREE-INCH VALVED UNISEX COUPLING
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Screwdriver, Cross Tip, Size 2
Key, Socket Head Screw, 7/64"
Dry Cleaning Solvent
Key, Socket Head Screw, 9/64"
Key, Socket Head Screw, 7/32 in.
Punch (Drift Pin)
Pick (or machinist's scribe)
Chemical and Oil Protective Gloves
Equipment Condition
Coupling removed from inlet
DISASSEMBLY
WARNING
Rubber gloves should be worn when handling fuel system components due to toxic
effects of some additives.
1.
Unthread dust cap attaching cable (1) from split ring (2).
2.
Place handle assembly (3) in closed position, rotate and remove dust cap (4) from coupling, then place handle assembly
(3) in open position.
3.
Remove two screws (5) and handle assembly (3).
4.
If handle assembly (3) requires repair, remove socket head screw (6), spring (7), and knob (8) from handle (9).
5.
Hold valve ball (10) with thumb and remove socket head screw (11) from handle-side shaft (12).
6.
Install one screw (5) in the handle-side shaft (12) and pull shaft (12) from housing (13). Remove and discard O-ring
(14).
7.
Remove and discard O-ring (15) and bushings (16) and (17).
8.
Hold valve ball (10) with thumb and remove socket head screw (18) from attaching-cable-side shaft (19).
9.
Reaching in the inlet end, rotate the valve ball (10) by hand and remove it from the housing (13).
10. Push out the attaching-cable-side shaft (19). Remove and discard bushings (20) and (21) and O-rings (22) and (23).
11. Use pick or scribe to remove seal wire (24).
0098 00-1