TM 10-4930-351-14
0101 00
ASSEMBLY-Continued
WARNING
To prevent injury to personnel, wear protective gloves when installing bumper.
Bumper must be softened in hot water and installed while still hot. Failure to wear
protective gloves could result in serious bums.
16. Soak new bumper (1) in hot water (160 - 180 F (71 - 82 C)) until soft. While still soft and pliable, press bumper (1)
onto collar (3).
17. If plugs (18) were removed during disassembly, apply teflon tape on threads of plugs (18) and install plugs into fuel
nozzle body (6).
18. Install continuity clip (31). Be sure continuity clip (31) is laying on the lip of the nozzle body (6) as shown in Figure 1.
END OF WORK PACKAGE
0101 00-6