TM 10-4930-351-14
DIRECT SUPPORT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPAIR D1-NOZZLE BODY ASSEMBLY
INITIAL SET-UP:
Materials/Parts Required:-Continued
O-Ring (WP 0117 00, Item 10)
Tools:
Tool Kit, General Mechanic Automotive
Wave Washer (WP 0117 00, Item 34)
(WP 0113 00, Item 1)
O-Ring (WP 0117 00, Item 74)
Chemical and Oil Protective Gloves
Screw (WP 0117 00, Item 85)
(WP 0113 00, Item 2)
Cotter Pin (WP 0117 00, Item 92)
Adapter MS24484
Cotter Pin (WP 0117 00, Item 93)
Back-up ring (WP 0117 00, Item 97)
Knife, Craftsman
O-Ring (WP 0117 00, Item 103)
Hammer, Dead Blow
Equipment Condition:
Hose End Regulator and Inlet
Elbow removed. (WP 0080 00)
Materials/Parts Required:
Bonding cable removed. (WP 0078 00)
Cloth, Lint Free
(WP 0116 00, Item 4)
Dry cleaning solvent
Petrolatum (WP 0116 00, Item 20)
Rags, Wiping (WP 0116 00, Item 21)
Tape, Teflon (WP 0116 00, Item 32)
DISASSEMBLY
WARNING
Exert caution when using cutting tool to prevent personal injury and damage part.
NOTE
Disassemble equipment only to the extent necessary for repair.
1.
Remove collar bumper (figure 1, 1) by cutting through the bumper.
NOTE
To prevent loss of balls and aid assembly, place a suitable container under body opening.
Catch all balls as they fall from opening.
2.
Remove screw (figure 1, 2). Hold the nozzle collar (3) with bolt hole vertical (pointed down) and allow all balls (4) to be
removed through the bolt hole. Manipulate nozzle collar to allow 49 balls to fall out of hole.
3.
Engage nozzle collar (figure 2, 3) to adapter.
4.
Remove fuel nozzle body assembly (figure 1, 6) from nozzle collar (3) by aligning the groove in the collar with dent on
body and pulling body from collar.
0101 00-1
