TM 10-4930-351-14
0108 00
REMOVE AND CLEAN OIL PAN. (Refer to figure 3.)
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Key, Socket Head Screw, 6 mm
None
(WP 0113 00, Item 3)
Key, Socket Head Screw, 5 mm
(WP 0113 00, Item 3)
Equipment Condition:
Socket, 10 mm
Engine removed from engine module
(WP 0113 00, Item 3)
Engine oil drained
Socket, 13 mm, deep well
(WP 0113 00, Item 3)
Ratchet wrench, 3/8" drive
(WP 0113 00, Item 3)
1.
Remove dipstick (1).
2.
Place engine on pulley end.
3.
Rotate engine to a position to allow for oil pan removal.
4.
Remove the fifteen cap screws (2) and flat washers (3) attaching oil pan (4) to crankcase (5). Remove oil pan.
5.
Remove and discard gasket (6). Clean gasket residue from crankcase and oil pan.
6.
Remove cap screw (7), washer (8) and net (9). Inspect and clean net and oil pan. Reinstall net.
7.
Restore engine to upright position.
1
7
5
6
8
9
3
2
4
Figure 3. Engine Oil Pan Removal
0108 00-4
